Atis Mirus

mirus

ATISmirus 100
sliding overhead with device for rollbar handling

ATISmirus 100
column

mirus 300 colonna

ATISmirus 300
column mounted with splinter-bar device

mirus 300 forche

ATISmirus 300
column mounted with device to handle forks for elevator trolleys

> ATIS mirus100 > ATISmirus 300

The manipulators, with parallelogram shaped vertical movement, allow the handling of loads even with jolts, in any direction without ties, with extreme ease and precision.

ATISmirus 100
column configuration with device prearranged for the use of magnets and the handling of stators

click on the pictures for details

They can be integrated with personalized gripping devices, planned and structured according to specific customer’s requests. Such devices are equipped with movement units which can be manual or pneumatic, and are necessary to the movement cycle.

ATISmirus 100
column configuration with pneumatic grab device for gripping and skewing stators for electrical engines.

click on the pictures for details

The ATIS manipulators are appropriately sized depending on the required performance and the gripping devices applied; they allow the gripping of loads with extreme ease, following the operator in each movement.

ATISmirus 100
fixed overhead configuration with device for gripping engine blocks in foundry

click on the pictures for details

The usability and functionality of the system are obtained by keeping the operator’s needs at the forefront during the planning phase; they are in fact considered by our personnel a fundamental part of the specific characteristics of the movement products.



click on the pictures for details

The parallelogram shaped are available in the following configurations: column mounted installed to the floor, column mounted with self-firmed base-plate, fixed overhead or sliding on overhead runway tracks.

Our manipulators do not need electrical power but only compressed air at 5-7 bar. This implies a remarkable reduction of the installation time simplifying the operation of the set-up of the working area.